News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - pjpedals

Pages1
#1
General Questions / Double Flush Rate LED
September 19, 2018, 11:30:10 AM
Hi all, anyone find the value on the LED resistor going to the rate LED leaves the blinking indicator WAY too bright? I presumed I could just increase the value of r11 (this is on the single side etch layout), but I'm thinking that might interact with the values going to the LED/LDR combo and perhaps change the sound. I don't want to do that. Any thoughts?
Pages1