News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - Soup39

#1
I just dusted off the old workbench and have 2 pcbs I can't identify.  I know with our pictures it'll be tough.  I'll work on uploading them.

Pcb 1 has "Santa distortion hohoho" on it
Pcb 2 has 7 diodes, 3 trim pots,  a dual gang gain pot,  along with bass/mid/treble & master pots. 



I'm stoked to be back at it and any help would be appreciated.
#2
Build Reports / Bloodstone Build
March 13, 2018, 01:44:07 PM
I never post build reports, but this one was done for a friend.  The request was for a phaser and maybe something green & orange.   The thing sounds gorgeous, so lush and plenty of phase on tap.  The on/off indicator doubles as the rate indicator and is hidden within the clear shaft pot.  Its hard to tell but there is orange, silver, & green foil layered with  the swirl.






#3
General Questions / Clear fader/slider knobs?
December 10, 2014, 11:12:52 AM
Anyone know where to source these?  I have checked all over and have been unsuccessful.  Thanks.
#4
Open Discussion / Common 2 in 1 effects pedals
September 16, 2014, 07:51:40 PM
I was kicking around the idea of boxing up a treble boost and "clean" boost into a single pedal.  Not sure if this is practical, so I was looking for input.

What are the most common 2 in 1 pedals out there or that you've built and enjoyed?
#5
General Questions / Skreddy Pig Resistor Value ?
July 28, 2014, 08:12:22 PM
Building a Skreddy P19 on an APIS SWARM PCB.  R19 is listed on Juan's terrific Muff doc as a value of  18k.  I thought I had some of these resistors  in house (sadly i don't). 

Not wanting to p wait on an order for a single resistor, am I better subbing in a lower 15k or  a higher 20k.  Or does this minor difference matter?