Topics

Hey everyone. I got this 1590B enclosure already drilled from an overdrive a friend never finished. The drilling scheme is non-standard since it's horizontal and it has 3 pots and 2 switches holes already drilled.

He was going to build a Zvex Distortron clone but i don't like how it sounds and I was searching for a similar layout. thanks everyone

here's a pic 

Hi everyone. I'm trying to build a devi ever Hyperion 2 clone but it doesnt work well. i'm getting a continuous loud signal as output and the guitar seems doesnt effect it.

here's the board schematic



and here's how i wired it offboard (its ugly but i hope clear to read)


(omitted the 2,2k res soldered to the LED)

I triple-checked the board and it's correct. where could it be the problem? many thanks

Hi everyone
I'm quite new to electronics and so far I've built some pedals just following the instructions and paying attention not to screw up everything

I would like to build the upcoming buzzaround + road rage voltage inverter, but I'm not keen on adding the sag pot.
the question is: which components can i skip to get just the voltage inverter? I really dunno
Thanks