Thank you, sir! 
Very helpful.
Very helpful.
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Build Reports / Re: Emerson EM-Drive Clone
October 08, 2013, 08:01:42 PM
Sorry if that sounds dumb. I mean, solder it directly to the tip at the input jack or the input side of the switch or something?
#4
Build Reports / Re: Emerson EM-Drive Clone
October 08, 2013, 07:20:50 PM
I have a production EM-Drive that pops, too! I see you used a 1M pull down. Where, exactly did you put yours? Kind of new to this. Any help is appreciated.
Pages1