Messages

http://www.duncanamps.com/tsc/index.html
Found this interactive tone stack calculator today and was wondering if some of the layouts could be used as a pedal.  I think these are tonestacks for an amp, but I think it would be great as an EQ pedal.  Is this possible?

Alright, I figured it out.  In case anyone else ever gets this problem, it was the SW and input tip connections touching.  It finally works and sounds amazing!  Great pedal Madbean!!! 

I partially fixed the problem, but now I have a bigger problem.  The light turns on and of when on/bypassed, but when I plug my guitar in, the LED goes faintly on and the guitar level drops.  When I roll back the guitar volume, the LED grows brighter.  When I turn the effect on, the LED lights up fully and the volume mutes.

(I'll take a picture as soon as I can)

Okay, I solved the problem and the LED lights up, but when I bypass the pedal, it stays on.
I think there is an accidental connection, but I'm not sure between which parts.

I'll post a pic as soon as I get a chance.

Ok, I tried everything with no avail.  Could it be something else?

so if the SW wire isn't connected correctly, the LED won't work?

Thanks I'll check it out!

Why is there only one wire going to the LED.  I can't get the LED to work on mine, is this because I used both wires into the two holes?

Hi, I'm building my first Madbean pedal, an Egodriver OCD Clone, and have a problem with the LED.  The pedal works fine and sounds great, but the LED does not work.  I've tried switching the contacts and even trying a new LED, but neither have worked.  Any idea on what might be causing this?

Thanks for any help!