Messages

hello guys ! I made two pieces of the mudbunny the green russian edition.I used the 5088 transistors.The only difference is that i used 330 ohm resistors in place of the 390 ohm.My sound is more a distortion with a bit fuzz.i compared it with mudbunnies at youtube and i can hear more fuzz at them.My hfe of the trans is about 350.I used my probe and i checked that the first boost stage gives me the same signal as the input.no boost at all.Any ideas ?

Hello.Can you please make a diagram with the bright switch?thank you!

claytushaywood did it work your loophole with the isd2560?I have one spare and i think to make a try.So the only think you have to do is to jumper 7 and 8 pins to ground?

Hello.Actually i don't have a gain problem but i need more gain from this.How i could do this ?changing the gain pot maybe ?Also i need more brightness from the tone maybe more mid range.for this i will change c8 and c9 .But with the gain ?

Thank you boys.That's exactly what happens to my pedals.Like the video Loztboy posted.crackle!So it works fine but i want to get rid of crackle at my Booster.
Thank you so much !

My krankosaurus has a problem.my Boost and gain pots make an anoying hissss when i turn them on especially after the last half rotation.The same thing happens and at one booster i made using the boost section of the krankosaurus.I have to say that i use 2n7000 and log pots and not anti log.
What really happens?

thanks for your answer.i ordered 10 pieces for 5 dollars

I have found the ICL7660S.can i use it for max1044?

thank you very much for your advise.I will check them!

I used this adaptor http://www.visualsound.net/index.php/products/pedal_power_supplies/1_spot_power_supply.It is a Jack Oman's Mosfet based booster.I used it with a MXR chorus powered both with the 1 pot adaptor.I tried also with an other adaptor alone.

Hello all.I have a problem with my power supply.It is a one spot supply.When i connect it to the pedal(booster) it makes a hum.When i plug a battery i have not any noise.How can i solve this prolblem?
thanks

Hello.I have Pop problems with most of my boost pedals and some distortion.When i plug dc in the circuit and turn on for the first time the 3pdt then it makes this pop sound.When i turn it to bypass and back to circuit signal the pop desapears.So it happens only the first time it takes dc.
P.S. i dont ground the input circuit at the bypass mode.Also i use 33 k resistors for my high brightness leds .