Messages

I noticed something else strange. If I clip to ground with my dmm and check pin 1 of IC3 it is at 14volts. If I touch my meter lead to the upper leg of capacitor 14 it goes to zero and slowly ramps back up to 14.37 volts. Pin 3 of IC3 is at 800mv.

Having the same issue 14v on 1,2 like .4v on 3 what did you do to make yours work?

Here are some photos

My voltages on q 1 and 2 are c 1.22 b .54 e 0 and c 2.9 b 1.2 c .61 respectively and from pin 2 to ground I am getting a range from 0 to .6 volts.

Hey Folks! Built the Violenzz and I have to say it sounds kick ass. The one thing I noticed though is that the fuzz control doesn't seem to have an effect at all. Did I do something wrong or is it just not very responsive? Thanks in advance.

Hey everybody! Was really wanting to build the aqua baby. Would I have to change the values of any other components if I were to use a mn3008 instead of the 3005?