Hey Chris how did you do the graphics on your sardine can? Was that a Tayda UV or did you do that yourself?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: blearyeyes on January 26, 2024, 11:07:01 PM
I ordered a Pickit Kit 3.5. I have the MPLAB software running. Hopefully it will recognize the hardware.
Hey with HEX code do you need to transcode it into binary before burning the chip?
Hopefully I'll figure it out.
Quote from: madbean on January 29, 2024, 03:50:44 PM
Desoldered this one from an old project today. Pretty sure I have one more around somewhere. Real mojo.