Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jjanssen1

Pages: [1]
Requests / 1590LB pedals
« on: September 17, 2014, 04:03:03 PM »
Hi all,
Just a thought ...
Could madbeanpedals make tiny smd pedals to fit inside the 1590LB enclosures available from places such as:

General Questions / Adding tap tempo to ZeroPoint Micro II
« on: September 04, 2014, 07:17:36 PM »
Hi All,
Currently I am building a Zero Point Micro II and I am thinking about adding tap tempo to it.
Does anyone know how I can easily add tap tempo to this project.

Open Discussion / Collosalus PCB out of stock?
« on: August 31, 2014, 05:24:40 PM »
Hi all,
I was just on the project page almost about to buy a Collosalus PCB and I realized it was out of stock.
Just wondering will it come back in stock again, and if so when will it be back in stock, so I will know if I should the other parts from Tayda and PedalPartsPlus ect...

Introductions / "Hello World"
« on: August 29, 2014, 03:42:21 PM »
Hi all,
I have been on this forum for "a while" now and realised I still haven't introduced myself,
Well, my name is Joshua and I am 12 years old, During my spare time I build guitar pedals for fun.

General Questions / Software for designing pedal graphics in?
« on: August 26, 2014, 06:25:10 AM »
Hi all,
Does anyone know a good software I can use to design graphics for a Madbean Zero point micro II I'm building soon
Much appreciated,

Build Reports / Valvecaster Tube BOOST/OVERDRIVE Build Report
« on: August 23, 2014, 02:44:03 AM »
Hi all,
Just wanted to show off my valvecaster I just boxed up...
And yes the tube changes colour


(another) Outside


General Questions / Fuzz Face Question?
« on: April 27, 2014, 11:17:59 PM »
Hi all,
I have a quick question about a Fuzz Face clone I am building
The layout I have already etched onto a pcb blank doesn't have a bias trim pot or bias pot. Is it ok to go on with building it or should I have a bias trim pot installed.
Thanks jjanssen1

Pages: [1]