Messages

I hate to see a fellow forum buddy in crisis, let me know if you want to try again and I can send you out a new board.  I've ordered some prototypes from oshpark, they take a long time to get here (about a month) but if you want one let me know jimi and ill send you the full kit again (for free of course).

Heres a picture of the update pcb.  Looks much better, the old version is just a bit of a cramped mess really.  This PCB was the first pcb I designed...for the record

Hi Chromesphere,
I would be interested in trying out SMD soldering, so do sell a kit or a pcb or something on your webstore that I could have a go at.
Cheers
Joshua

Hi all,
I was just on the project page almost about to buy a Collosalus PCB and I realized it was out of stock.
Just wondering will it come back in stock again, and if so when will it be back in stock, so I will know if I should the other parts from Tayda and PedalPartsPlus ect...
Cheers
Joshua

Hopefully populating a zero point micro II board then maybe box it up if I have any time.

Hi all,
I have been on this forum for "a while" now and realised I still haven't introduced myself,
Well, my name is Joshua and I am 12 years old, During my spare time I build guitar pedals for fun.
Cheers
Joshua

Thank you all for your help,
I think for now I will use GIMP and someday (when I have the money) will move onto using Photoshop
And also does anyone have any enclosure templates made up for GIMP?.
Thank you all again for your help
Joshua

Hi all,
Does anyone know a good software I can use to design graphics for a Madbean Zero point micro II I'm building soon
Much appreciated,
Joshua

Hi,
I checked on the JMK PCB's taptation implementation guide and it says to not connect the resistor next to pin six and solder the wire directly onto the pin 6 of the PT2399. It also said to not connect the time pot.
Hope this helps
Joshua
P.S here's the link
jmkpcbs.com/wp-content/uploads/2014/03/Taptation-Implementation-Document.pdf

Cool- how's it sound?

wgc
I'll post a demo tomorrow
Joshua

Hi all,
Just wanted to show off my valvecaster I just boxed up...
And yes the tube changes colour
Outside:

Inside:

(another) Outside


Joshua

Hi Madbean,
Cool Effect
Just a quick question how did you do the artwork?
Cheers
Joshua

Hi all,
I have a quick question about a Fuzz Face clone I am building
The layout I have already etched onto a pcb blank doesn't have a bias trim pot or bias pot. Is it ok to go on with building it or should I have a bias trim pot installed.
Thanks jjanssen1