Messages

Pad 3 of the mix pot pads on the PCB to panner input and panner output to lug 3 of the mix pot.

Excellent. Thanks so much for all your help!

You can also use the JMK panner or Rockhorst's panner (PM him).  I have used both of these for dedicated fx loops on the repeats or board outputs of various delays and they work great.  Also there is the TH-Custom madbox which would work if you jumpered the in/out pads of one side of the mixer.

The JMK panner looks great, hopefully they're back in stock again at some point. Sorry if I'm being a little slow here, but where abouts would the panner PCB be placed so as to work as an fx loop/splitter on just the repeats?

Thanks everyone! Super helpful. I may resurrect this thread when I actually get stuff ordered and give this a go, as this is my first attempt at doing any combining/modding so I'm sure I'll get slightly lost at some point 

Now that I'm thinking about it, I kinda like the idea of being able to send just the repeats to other effects and even another amp. If using a panner or effects loop, would it be possible to do that, or would it have to terminate back inside the pedal to be mixed with the original signal?

Cool idea. 

I'd consider doing the zero point solo with a dry output and a wet output.  Then you could put whatever you want on the wet.

That's an awesome idea. So you could do it with 2 output jacks, one clean only, and one repeats only? Kind of like making it stereo?

I've done this a number of times with the Zero Point DD now.  It is easiest to connect the input of the smoothie to mix pad 3 on the PCB and the output to lug 3 of the mix pot.  I have been using Stomptown Galacticon and Galacticon Deluxe phase shifters from the FS section here and find the blend control to be very useful.  You might want to consider adding a toggle so you can bypass the smoothie unless you are building to be a dedicated delay+phase.  Here's some of mine with it:
http://www.madbeanpedals.com/forum/index.php?topic=14872.msg139369#msg139369
http://www.madbeanpedals.com/forum/index.php?topic=14125.msg131100#msg131100

Awesome, sounds cool. I'm thinking of keeping it more simple, leaving the phase always-on for the repeats.

Another question - I have a 125B enclosure laying around - does anyone know if the Zero Point Micro and Smoothie would be crammable in there?

I've only ever built a few BYOC pedals and I'm currently working on my first MadBean (Mangler), but it got me thinking of trying a two-in-one of a Zero Point Micro into a Smoothie in one enclosure. I'm not savvy in this in the slightest, so if this is stupid I apologize, but would it be possible to send just the repeats through the Smoothie while keeping the original signal un-phased?

Thanks!