News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - BrianS

#16
Build Reports / Re: Godzilla (II) - Pedalpcb BE-OD
April 01, 2020, 02:11:38 PM
Nice.  The UV print looks good.
#17
Build Reports / Re: VFE fiery red horse
March 27, 2020, 04:15:59 PM
Nice build.
#18
Build Reports / Re: FAT PANTS
March 27, 2020, 04:11:10 PM
Nice.  Have mine built and the enclosure came yesterday.  I've tired two of the baby board builds and some how managed not to screw them up.  Hope this one turns out as good as yours.
#19
Nice job.  I really like your art work on it. 
#20
Looks awesome.  Graphic is really nice.
#21
Open Discussion / Re: Hermit Superpower
March 26, 2020, 12:30:48 AM
Quote from: EBK on March 25, 2020, 10:00:45 PM
I'm learning how to fart letters of the alphabet.  During my premiere recital, my kids stopped me after P.U.  They were not impressed.

(Sorry.  I'm losing my mind here.)

Hilarious.
#22
Build Reports / Re: centaur?
March 19, 2020, 03:38:19 AM
Nice and clean.  Looks great.
#23
Build Reports / Builds I’ve Finished This Year
March 17, 2020, 01:09:04 AM
I've finished a few pedals since January.  Some of these are things I just couldn't get to go that were started a while back.  Anyway there's a few so I hope no one is offended by the amount.  Jimilee this photo gallery is for you.  You got me motivated to get off my rear and finish these up.

The Florist.  I did this in one day and it worked which is very unusual.  Really easy build and sounds great.

Sagan 2.  DiabloChris's board and his graphics.  Pedal is awesome. 

Another one of Chris's boards and this has been on going since 2017.  Really fun to blend 3 effects into one.

Octagon PedalPCB.  I had this built but had never put these sharp graphics on which are courtesy of Gordo.

Xotic Box.  Dan Schumaker's 1590a boards.  I had a 1590xx that I had totally screwed drilling I think DiabloChris's Dueling Herbies.  That's why there is tape inside covering holes.  Dan makes some really good boards.

This is Rullywows Eaglet.  Ben pif'ed it to me 2 xmas's ago.  It's a nice overdrive.

Wolfshirt.  Things don't always work right when you have the transistors backwards. Awesome octave pedal.

Hipster.  This worked fine when I tested it an once inside the box I started having problems.  After several in and outs I had some bad jacks.  Replaced them and this thing rocks for such a small pedal.

Harbinger.  I just could never get this thing to work.  After several attempts I just put in the does not work box.  I started pulling them all back out and got lucky with this one. 

Guitar PCB Sunn T

Mud Flap.  Triple Wreck clone.

Honey Bee clone.  Board is from Aion.

Dimension C Chorus.  Aion board.  I got this back when Kevin started selling them.  The effect always worked but I could not get it to bypass a signal.  This thing has been rewired like 3 times. The last time was the charm and it works.  Really nice sounding.

AlanP's Horace board.  This thing rocks.

One of the few vero builds I've done and boxed up. 

Cerulean. Aion board.  If I'm not mistaken I think this was modded as a Morning Glory.  It sounds nice.

Ace Tone FM-2 Fuzz.  This came from MB member imjohnwain and it's a solid little pedal.


Sent from my iPad using Tapatalk
#24
I think I did that on my 3rd one.  Just be careful when you desolder.  The pins are not very strong.  Do one and wait bit before you move to the next one so you don't overheat the controller.  As long as you go slowly you should be ok.  I would prime each pin with a little extra solder to get it to flow quicker.  If you can clear each pad the first time you'll be golden. 
#25
Build Reports / Re: Glitchee
March 15, 2020, 01:48:45 AM
Quote from: jimilee on March 15, 2020, 12:47:53 AM
Quote from: gordo on March 15, 2020, 12:38:13 AM
Picked up this board because I liked the demo and thought it might be interesting.  Holy crap this thing is fun!!!  Not boxed up yet, it's on my test rig but I spent the last hour diddling around with it.  All kinds of cool sounds in this little beast and for being such an odd effect I think there is plenty of prime time usage to be had.

Pics to follow.
So you diddled your glitchee?


Sent from my iPhone using Tapatalk
Quote from: gordo on March 15, 2020, 01:37:17 AM
Indeed.  For an hour...

Always a breathe of fresh air to see some of the humor that flows on here.  Gordo I hope your Glicthee diddle was fun.  Sounds like something Aerosmith could make a song out of.
#26
Back a few years ago the last hurricane that blew into south TX caused a run on gas stations and it took almost a week for things to return to normal.  The media was actually trying to help by telling people to stop and carry on normally and things would be OK.  Of course that didn't happen and people were driving all over San Antonio trying to find gas.  The storm blew east of the area and all the flash flooding, bad weather was pretty much nonexistent. I was making a joke about selling TP at the intersection and then I clicked on the below article and stopped thinking that way.  Is this a little bit of justice, getting 17,000 bottles of sanitizer shoved up your rear, for trying to profit off an emergency?  But I'm sure he is not out any money since he was selling it for $8 to $70 a bottle.

https://www.msn.com/en-us/news/us/he-has-17700-bottles-of-hand-sanitizer-and-nowhere-to-sell-them/ar-BB11blvS?ocid=spartanntp
#27
Quote from: EBK on March 14, 2020, 02:28:14 PM
Quote from: BrianS on March 14, 2020, 02:24:46 PM
Perhaps you'll start seeing people profiting by selling it by the row at intersections.


LMAO.
#28
It's crazy.  My wife went to the grocery store yesterday and said it was nuts.  Practically all the meat was gone and of course the toilet paper.  Perhaps you'll start seeing people profiting by selling it by the row at intersections. 
#29
Build Reports / Re: The good, the vero and the ugly
March 07, 2020, 01:50:46 AM
Bro you're killing it. 
#30
Quote from: jimilee on March 01, 2020, 08:33:41 PM
Quote from: BrianS on March 01, 2020, 07:54:25 PM
So impressive.  I chickened out and paid the extra money for the pedal.  It's still in the freaking box lol.
Who was selling them? I took it slow when I was building mine. Fortunately, I fixed mu mistakes as I went. It's any easy build overall; there aren't that many parts.

When I bought mine Peter was selling both the kits and a completed pedal.  I think the completed one was $100 more than the full kit.  My build success rate then just didn't justify a $200 plus dollar failure.