Topics

Came out great looks and sound wise. I love it! BC109's

[only]

I built the board according to the layout but haven't boxed it up yet and then noticed that Brian has a update regarding  a diode change to 1n5817 and 100uf for C26. He indicates that his helped with the clock noise on his prototype only.  Now I am confused.
Should I leave it stock or make the changes in the update.
Thanks, David

I want to get the orientation of the LED's on the boneyard correct and I forget. Square pad (+)?

Could someone help me with the orientation of Q1 in the Weener Wah. Thanks

Can someone help me with the orientation of Q1 on the Weener please and thanks

I wanted a little help understanding the clipping section on the Uproar circuit.  Basically I wanted to remove a pair of diodes to reduce the amount of clipping and I am not sure which pairs to do.  I have it set up like the build document dictates. Thanks for any help.

First MB build post. Used both C10, 12 mods. Hvent really cranked it up too much yet but what I heard I liked so far.

I just finished building a Low Rider.  Why are there 2 9V pads on the board. Is one for the LED? Thanks

Anybody have an idea for component change to increase the octave up effect of the retrograde.  I think it is a bit too subtle for me. Thanks

Hello, just build a chunk chunk. Presence and  BMT work fine however volume and gain pots do not do anything.  Trannies are biased fine. Cant figure it out. Any help would be great. Thanks

Just built a Chunk Chunk.  Works OK with the exception of I cannot bias T2. No matter how I turn the trimmer, I still get the same reading (about 9V) on the drain.  Thinking it may be a bad trimmer but unlikely.  I need some help. Thanks, David

Hello,  I am attempting to build my first pedal (Firebomb).  I have modded a few pedals previously.  I am sure that this question has been addressed a thousand times before however which is the best choice for resistors ( metal film or carbon comp). Thanks

Hello, Newbie to pedal building.  I will be building a new firebomb and would like to eliminate the battery source.  Will the jack serve as a ground as I have noticed that w/out the battery clip there is no ground going to the jack?  Thanks