Great artwork and the insides look neat. Nice job!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: BrianS on May 02, 2016, 12:16:13 AMI've just begun testing them beforehand, however as I don't buy in bulk I'm pretty much using whatever ordered. A value has to be way off for me to ditch it, cheapskate that I am
One thing that I learned from a member on this forum was to check every resistor with my multi meter before using it in a build. Is it monotonous, yes (especially when you have a large resistor count), but it will keep you from potentially making a mistake. My rate of success on first time fire ups went up a lot after I started doing this. I use a piece of styrofoam and line up the resistors according to the build doc and start measuring them. It's pretty much fool proof if you go slow when you start putting them on the board.
Quote from: drolo on April 26, 2016, 08:34:02 AM
Looks like someone finally put this into practical use :-) :