Messages

Having trouble finding the 250K trimmers, nobody has them not even ebay.
Will these Tayda ones work in place of the Bourns 3362p?

http://www.taydaelectronics.com/250k-ohm-trimpot-variable-resistor-6mm.html

1100ms would be a game changer

Great great great!

ya , some of the xicon's werent in stock so i just went with all vishay, epic failure

Just a heads up about these. I ordered a bunch from mouser for some of the new projects. They are full size and wont fit the new mini boards.

Instructions say to omit R8 for true bypass wiring. Should i remove it from the pcb?

sounds good.  i'm gonna build one as soon as they're available.

will the Timelapse support (4) MN3005's? Hopefully so to get close to a ehx tt1100. My BBD's await. Any eta on the project?

Awesome! I built this one too and i love it. I ran into a similar issue as yourself with the grounds. Since the pedal is positive ground it can be funky. Just make sure you isolate the DC jack from the enclosure (i used a plastic jack). Also, take the Bias instructions with a grain of salt, when i followed them my results were nowhere near what the instructions say. I wound up biasing by ear without a probe and it sounds fabulous. Grats on your build

i'm a noob at this but the sleeve pins maybe try wiring directly to the input/output jacks grounds. Maybe a ground issue

Thanks my friend. They are lower than the regulator so i guess I'm good.

C10,C11 1n caps. I forgot to order these so i used the following, ok?

i'll have to try and make a video. The chorus is there it's just not as thick as i was expecting.

Finished my Pork Barrel. Everything's working as it should and i biased it. Using, the MN3007 BBD. It seems the effect isn't very prominent (wet). With the depth maxed it makes a subtle chorus effect. Was wondering if this is expected?

this is just Fabulous!