Messages

Sonic Boom

i am so excite for Low Rider OCtave pedal.

i think i bought some on a whim, I'll go find it.
if you're wondering, i havent used it because i also bought some teflon insulated wire off ebay that i am loving.

The store will re-open tomorrow. The new projects will be the Quadrovibe, Tilt and Loophole. There will be some new sale prices, too!

oh, no octaver yet?

Oh, oh, oh, I hope madbean has a Pearl Octaver project for me. 

Passive tonestacks like these are lossy, meaning they need to have a gain recovery stage after them. Also, many of them need to see a low impedance input. So you would need a buffer before and after most of these tonestacks.

Oh man! This is going to be an awesome build!

Favorite flanger, no doubt.
Is there a possibility for Through Zero flanging?

I am willing to make you a Zygote board, no problem.

PM me.

Wow, I just bought some Papillio adhesive paper and vinyl, but I may stop by Walmart too to get some of this.

Good to know that Rustoleum worked well, I'm using that right now, too!

So you clearcoated over the photo paper?
Any color bleeds?
Did you bake it to cure the clearcoat?

Dirk's build is totally amazing, but it's also all SMD. The Dirtbag will be all through hole in a 1590BB. Man, I really want to finish it....I have at least 10 projects in some form of completion right now.

No worries, I am a patient man.

Plus I'd be all over yours, through hole would be much more DIY friendly, as said before. a 1590BB shrink is no small feat for the DMM design, either.

All of this stuff is still going on. I haven't had any time in the past two weeks to finish up projects, unfortunately. I think by next week I should be able to start getting some of the stuff out.

Then I am excite.

Man though, Dirk Hendrik beat out our your Dirtbag Delay in terms of DMM shrinkage, though.

I'm also still very pumped about the Pearl Octaver project I saw you post on DIYSB a while back, madbean.