Messages

I get them from Tayda. My experience is that the powder coating is a bit delicate, and you need to baby them until you clear coat, but they look fine.

After.

Edit: It works.

I've got the flu so it's going to be a few more days at least.

Feel better, no pressure. Have some chicken soup and ibuprofen.

Any news?

Varioboost. (That would be a challenge to get into an A, especially with the dual-gang pot).
ROG Mr. EQ or Tonemender.

Beautiful. Enjoy her, Jon.

Hotcake into an AC -- that's the Neil Finn lead recipe (along with a gold top Les Paul with mini-humbuckers or a Gretsch Firebird Jet and a Tweed Deluxe).

Mattias, do you think the Taprecise could be made to control a Mitsubishi M65831AP (the chip in the Ibanez EM5 EchoMachine)?
Ben

So in theory, Could you isolate the outputs of a 9v daisy chain (like a One Spot) by putting a smaller(cheaper) 1:1 transformer at each output?

Transformers block DC, so I don't think it's possible.
You could use small 1:1 transformers after another transformer to have isolated outputs, but I think it's cheaper order a custom transformer as the voodoo-lab one.

Correct, you can't use a transformer on DC. As for DIY, Weber sells a multi-secondary pedalboard power supply transformer. For other full-isolation solutions, check the Spyder article at Geofex.

Too funny
I work for USPS and am a letter carrier. If you had a priority package returned since July... well Blame it on those stupid clerks or mail handlers... Sometimes they will keep tossing a package to us carriers that is a RTS and they go back n forth but...
Since JULY?   wow 

Is that Return to Sender or Ready to Solder?

Any chance of a board being available for this amazing project? I know it's been a while, but I am just getting into my Deep Blue clone (Aion), and this would be a sweet addition.