Finally finished the project (waited to accumulate parts for a Mouser order). Works like a charm! Thanks for the help everyone
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: fair.child on July 09, 2019, 09:37:46 PMQuote from: DLW on July 09, 2019, 09:31:43 PM
Thanks a lot for sending these pics. I'm mainly struggling with the MLCCs. The 100p is under the Belton and the 22p is clearly marked on towards the bottom of the board. The rest are presumably 100n, but there are 5 remaining spaces for 2.5mm caps on the board and only 4 listed in the BOM. Does that mean one of the caps should not be populated, as is the case on several VFE pedals I've built in the past? Or, should I fill all 5 places with 100n caps?
I actually have the .brd and .sch files from VFE. Is this information in those files? If it is, I'm not seeing it.
Okay just to make it clear. When you see PWR marking on the cap, it should be 100nF MLCC. Other than that follow the marking like 22pF underneath the op amp. The op amp should be socketed. The BTDR brick shouldn't be socketed. I think I had a build report somewhere here. Might want to check that one out as well.