Messages

Is the degenerator sold out? I was able to add to cart, but it flagged an out of stock error.

Happy birthday, Brian!!

Awesome build and story! I'm sure he'll dig the pedal!

Anamorph build docs are up. PCB releases tomorrow!

Incredible project!

...and I had just picked up more BBDs to make a few choral reefs! Bad timing.

This issue is confusing. How can the SOFT and HARD controls be operating properly if you only have a tiny bit of overdrive? Those controls determine the clipping characteristics of the circuit.

Wow. I'm really sorry to hear that, Brian. Very glad you're out of the hospital though. Hoping for a smooth recovery.

IC1 pin 5 is NC and shouldn't have any voltage on it and it's left floating. The build doc lists pin 8 as 'ignore'—it's a part of the offset nulling with pin 1, which aren't being used here.

Brian: Are the voltages listed in the build doc correct? Those don't seem right to me.

Stellar all around! Great addition to the series, and incredibly impressive job with the board designs and execution!

Dig it. Getting a lot of versatility out of the Electra! The consistent volume with the diode control is particularly useful.

Congratulations! Good luck with the job search!

Looks fantastic! Circuit combo and design are all stellar.

Any of the mcu chips are probably not useful in pedal circuits. Although there might be op-amps and CMOS logic in there that could be.

They'd never splurge on aluminum knobs.

Congratulations!