I've just completed a 'Loophole' but I'm having an issue where both the red and green LEDs are illuminated when in Record mode. Play mode seems to be fine, only the green LED lights up. I've had a look to see if I had a solder bridge between the LED connector pads but it doesn't seem to be the problem.. not 100% though. Please excuse my terrible soldering job, this is my first project using an etched board! Everything else works apart from the detune momentary switch because I think I may have overheated one of the pads. The LED thing isn't the end of the world but I just thought I'd post in case anyone had any ideas? Thanks