I have it all wired up, as per the diagram, and as the switch wiring diagram shows for it having the Positive and Negative 9V, but no sound is coming out of the pedal. Not even through the pedal. Any ideas?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#22
General Questions / Effects Connection parts site...
August 19, 2011, 11:11:42 PM
Is it down for anyone else? I was about to put an order in today and its not up on my end.
#23
General Questions / Capacitor question, in general.
July 29, 2011, 06:55:16 PM
I am new to building/creating pedals and I recently purchased a handful of boards from the site, and while Resistors are a piece of cake to source I am having a mild problem with the Caps, as certain codes on the board layouts are confusing me, Namely these.
the 3N on the Wolfshirt, is that a Film or a Box Cap?
Same with the 50N. I have seen silver mica caps with this value as well as a few others?
On the Chunk Chunk pedal I ran into the same problem.
I know this is probably a total noob question, Its just confusing me a bit and once I learn how and what they are Ill remember it.
I have been trying to compare and deciper the codes from what I am reading here with no luck. http://www.wjoe.com/capacitorinfo2.htm
Any help is greatly appreciated!
Also, where does everyone source their pots from?
the 3N on the Wolfshirt, is that a Film or a Box Cap?
Same with the 50N. I have seen silver mica caps with this value as well as a few others?
On the Chunk Chunk pedal I ran into the same problem.
I know this is probably a total noob question, Its just confusing me a bit and once I learn how and what they are Ill remember it.
I have been trying to compare and deciper the codes from what I am reading here with no luck. http://www.wjoe.com/capacitorinfo2.htm
Any help is greatly appreciated!
Also, where does everyone source their pots from?