News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Dhendo

#1
Build Reports / Re: Serendipity
June 22, 2010, 02:41:37 AM
Hey, sorry haven't checked this board in awhile. The wires are supporting the PCB in the middle, I actually went through and rewired the pedal so I could get the PCB more towards the end of the box.

As for sounds, I'm really terrible about explaining stuff but it sounds a bit tubescreamer'y to me at times, and changes a lot by playing with the tone and voice knob. I also didn't like it with the gain knob past 12/1ish. Haven't played a real ZD but I'm happy with Robben Ford and John Mayer overdrive tones I can get out it
#2
Build Reports / Re: Serendipity
April 18, 2010, 06:57:59 PM
Thanks! I used a 125B and I cut the clearance pretty close but it just fits. I ended up bending the LED leads a little bit so I could push the PCB down further.
#3
Build Reports / Serendipity
April 15, 2010, 10:02:49 PM
After a super easy LED fix the pedal is all done. Took a picture with it in the sun to show off the sparkles haha. It's not as neat inside as I would like but I'm slowly getting better.





#4
Tech Help - Projects Page / Re: LED not workig
April 15, 2010, 09:04:48 PM
Just switched it and it works!!! Thanks so much for your help
#5
Tech Help - Projects Page / Re: LED not workig
April 15, 2010, 06:40:02 PM
Okay here is a picture of the board. Just to possibly eliminate any stupid mistakes on my end, I've got the longer lead going through the square solder pad.


#6
Tech Help - Projects Page / Re: LED not workig
April 15, 2010, 03:53:18 AM
I wired it up following the project file. I just checked out the bezel and the leads don't seem to be touching.
#7
Tech Help - Projects Page / LED not workig
April 15, 2010, 01:46:43 AM
I just completed the serendipity build and everything is working (it sounds awesome) except for the LED. I know this is a good problem to have but not sure what I did wrong. I used an ultra violet 5mm LED. What should I trouble shoot first?
#8
General Questions / IC chip question
April 04, 2010, 12:28:49 AM
I'm gearing up to do the serendity (zendrive) project and some on freestompboxes suggested I try a OPA2604 in the build instead of the ones listed and wanted to know if this would work in the layout for the pcb here.