Messages

Project: Quasar morded for Bass (Rc Boost)


I have a problem with my pedal and I've tried potentiometer gain not respond, could you tell me where I can start to correct what may be wrong.

I'll post some Photos later.

 Ok Thanks Jacob 

 Hello someone know how can i check if a cap doesn´t work, when the cap is on the pcb. ?

     There is any board available for me?

Hello guys im thinking to buy a mammoth wah enclosure, but i read some negative feedback about those, someone has trying

  Muy buenos pedales. Saludos 

   I don't Know what is the next step to debug the Board. Thanks For ypur Help

  Blessings

   Thomas sorry for the delay.

   The Modulaterator already works but the Led is not workink yet, flashing at the rate.
   
   I found one error in the Vero Board:

   - The two resistors (100k) that run from the +9V & GND to the pin 5  should go conected to the pin 6.

    Since I Found this error I check my wiring and I found another error, I connect wrong the terminals of the rate pot so i fix it. After that I connect the Board to the DElay 1 Terminal of my ZPDD Board and Work only the Depth Pot  cause when i turn it i heard something (i don't know how describe it, sorrry for my bad english i hope you can undestand me ) but when i turn the rate pot anything happend  and the Led is still not flashing.

     And after that I check the ZPDD Deluxe and i see that the "Opamp LFO" is identical  with the Modulaterator Board and i realize that
that the ZPDD Deluxe Opamp LFO use it a 1MC instead a 1MB  Rate Pot

  ok thomas i will check the wiring connections.  and i will post photos tomoorrow.

  I check the B.O.M. for the ZZSDX and the Rate LED is a 3mm and in my veroboard i use a 5mm led this could be the problem? that it not have enough voltage?

  Recently I made the version of modulaterator for veroboard, I tried it with ZZPD but the LED does not blink . The modulation is heard but not flashing LED
  This is the veroboard wanted to help me find because the LED does not blink. Thanks in advance 

   Hello Madbeaners  I wOnder if its possible use the Zero Point Super DEluxe with some keys or a syntetizer, I ask this question because I read that this type of device has a high output impedance and would like to know if it is compatible. A friend wants one and would like to be sure that the pedal  serve him, HE uses a M-Audio midi controller, Reason and a M-Audio mtrack Plus. Thanks in advance.

Great clean build !!!!!! The color is awesome

 

You need sometime like this if you dont have enough money for a drill press. i have one of this and is very helpful with a hand drill.

Ok i think i get it !!!! jejejejejeje   The next is the schematic for a common expresion Pedal:

http://www.strymon.net/2010/07/12/strymon-tech-corner-1-anatomy-of-an-expression-pedal/

But What happend if you double the schematic and use a double gang pot (25k-B like in the manual) instead a single gang pot.