Messages

ok here we go!
4558             3207             3102             tl062
4.44              0                   8.07             8.27       (1)
4.43              3.93              3.92             .75           
4.37             3.74               0                 3.72
0                 7.54               3.94              0
8.94            5.09                7.54              8.94
4.42            5.09               2.18              .65
4.43            3.92               7.82              2.49
4.41            8.07               .19                .75        (

Q1
.46     .94     8.94
Q2
3.75    3.86      8.94
Q3
3.65      3.16    8.94
Q4
0       .28     7.17
Q5
.21     .53    8.07

I hope this is what you needed. If you need measurements on the IC's please give me a brief run down on how to do that.

for trannies? Just making sure. Sorry still a little new here.

Ok so a few notes... the board looks like it may be touching the switch but it is actually sitting on wires. Im pretty sure it grounded out... im just not sure what it screwed up ...and if i can figure that out i could fix it.

I will try to get photos up soon. When i bumped it i pretty much feel off the stool I was sitting on while adjusting the rate knob. I believe that the knob might have been loose enough that it moved and grounded out on something possibly. I was not sure if this would fry a pot or trannie. Ill make sure that when i get a change Ill go over the grounding again. Might the power supply be an issue aswell?

Ok so I built the pork barrel. It worked for awhile and then I bumped the box. I got a couple of pop noises and the lights went out. I replaced the leds. they both worked but the lfo indicator just went on and did nothing. Now the lfo indicator doesnt go on at all. I replaced both the 3207 and 3102 and still nothing. I will try to get pictures as soon as possible. Any guidance would help. Could it be the transistors? should I replace the other IC's?

Bypass works, and I get full sound when engaged, just no effect.

fixed it

my appologies it is is a v.1  I checked the trannies q1 2 3 all messure .10 when the dmm is set to 20k ohm ( not sure if i did that part right) here are some pics... please help. i can tell it has great tone in there , its just this buzz that i get when the pedal is turned on.

OK so built a gruntbox and everything is great except that the sus knob has some horrible buzz to it. when you turn it up it just gets worse( it is there even at zero) checked all my connections. went over my wiring many many times. not sure what the issue is. This is only my third buidl so maybe there is an area that i over looked. can anyone point me in the right direction?

Ok so quick one here. Could I use a footswitch on the slow loris instead of the toggle switch like the one that is used in the wiring diagram for the boneyard?