Was going through my Mouser order and these did not look right. The resistors on the left are supposed to be 1/4W 10K for the Egodriver. The resistors on the right are 1/4W 1M for size comparison. The 10K's look too small to be correct, are they maybe 1/8W? I don't want to get started on the board until I know for sure. Also what is the purpose and pros/cons of the R1 pulldown resistor?
- Welcome to madbeanpedals::forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#408
General Questions / 1n34a Diodes?
March 07, 2012, 09:00:06 AM
Are these the correct diodes for the 1n34a on the Egodriver and are they ok to use? Mouser has a note on the page that says "not recommended for new designs".
http://www.mouser.com/Search/ProductDetail.aspx?R=1N34Avirtualkey52600000virtualkey526-1N34A
http://www.mouser.com/Search/ProductDetail.aspx?R=1N34Avirtualkey52600000virtualkey526-1N34A
#409
General Questions / Re: Noob parts question
March 02, 2012, 02:55:16 PM
Cool Thanks! How can you tell the lead spacing?
#410
General Questions / Noob parts question
March 02, 2012, 02:14:45 PM
For 220pf cap on the Egodriver is http://www.mouser.com/ProductDetail/Xicon/140-50P2-221K-RC/?qs=sGAEpiMZZMsh%252b1woXyUXj3vaHGRyT6H%2ft86oHPmVFeE%3d the right cap? Figured out the resistors but still having trouble figuring out the cap ordering. Seems there is a ton of options and the voltage is the variable. I'm assuming the higher the voltage the bigger the cap?
#411
Global Annoucements / Re: February Releases - give your input!
January 21, 2012, 07:28:47 AM
Rump Roast and Harbinger!