Messages

I finally got around to getting the NomNom v2014 built. I fired it up and it passes sound but there is no phasing. I have the default diode in there and haven't tried the 4.7v Zener that is suggested in the doc.

I'm using a quad set of 2N5952 from Guitarpcb that I had gotten a while back.

Here are the voltages I am seeing

Source Voltage - 8.9v

TL074
1 - 4.10v
2 - 4.10v
3 - 4.10v
4 - 8.10v
5 - 4.10v
6 - 4.10v
7 - 4.10v
8 - 4.09v
9 - 4.09v
10 - 4.09v
11 - 0v
12 - 4.10v
13 - 4.10v
14 - 4.09v

TL072
1 - 4.09v
2 - 4.09v
3 - 3.90v
4 - 0v
5 - varied
6 - varied
7 - varied
8 - 8.10v

When I hook up the led the lfo looks to be working and it varies with the spd knob

Q1 - 2n5087
e - 4.10
b - 3.55
c - 2.45

Q2-Q5 - 2n5952
g-4.10
s-4.09
d-3.40

They are all reading the same give or take a hundredth of a volt. The voltages look odd to me, but I'm not sure why. I have a working smoothie that I haven't tried reading voltages from yet...

I have some 2n5457 that I am working on matching and will try those later.

Any suggestions? Sometime fresh eyes help...

Thanks for any help!

Yup, same as above. I've also got in the habit of ordering something I 'think' I don't have only to find that I already have multiple...

Fantastic, thanks!

  Thanks! glad to hear a happy 'mistake' has turned into something good.

Aaron

Gut shots

Yup it is a benefit. I also would turn one on, and then stomp on both switches which would turn that one off and the other on...kind of saving a stomp...

It was a fun challenge to cram it all in there

I finally finished up my Aristocrat last night. I got it crammed into a 125B enclosure. The stompjacks are close, but its the best I could do.





I'm going to have to order some other boards soon...