Topics

[Pcb 1]

I just dusted off the old workbench and have 2 pcbs I can't identify.  I know with our pictures it'll be tough.  I'll work on uploading them.

Pcb 1 has "Santa distortion hohoho" on it
Pcb 2 has 7 diodes, 3 trim pots,  a dual gang gain pot,  along with bass/mid/treble & master pots. 



I'm stoked to be back at it and any help would be appreciated.

I never post build reports, but this one was done for a friend.  The request was for a phaser and maybe something green & orange.   The thing sounds gorgeous, so lush and plenty of phase on tap.  The on/off indicator doubles as the rate indicator and is hidden within the clear shaft pot.  Its hard to tell but there is orange, silver, & green foil layered with  the swirl.

Anyone know where to source these?  I have checked all over and have been unsuccessful.  Thanks.

I was kicking around the idea of boxing up a treble boost and "clean" boost into a single pedal.  Not sure if this is practical, so I was looking for input.

What are the most common 2 in 1 pedals out there or that you've built and enjoyed?

Building a Skreddy P19 on an APIS SWARM PCB.  R19 is listed on Juan's terrific Muff doc as a value of  18k.  I thought I had some of these resistors  in house (sadly i don't). 

Not wanting to p wait on an order for a single resistor, am I better subbing in a lower 15k or  a higher 20k.  Or does this minor difference matter?