News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - 65gmcjnew

#1
Open Discussion / Re: Total Time Logged in
March 26, 2019, 08:35:16 PM
Mostly lurking,  18 days, 20 hours and 33 minutes.
#2
Tech Help - Projects Page / flabulanche zener
February 27, 2016, 10:03:46 PM
was working on this today, and noticed that I didn't have a 15v zener,   I do have a 16v zener,  or a 12v zener.  I was planning on running it on 9v(input)  was wondering if either was a ok sub,  or should I really hold off until I get the correct part..  Thanks
#3
Open Discussion / Re: Dirtbag - General Question
June 29, 2014, 03:46:31 PM
another vote for the 4 X 3008/3208
#4
yes weber was the original makers of the scumback.  until scumback basically stole a shipment of speakers from them.. the sigs are nice speakers as well,  my fave is the sig 12b.
#5
I have no experience with the 5%,  I use the 100% spray,  S-CF100S-L2  it is nice that it is pressurized to ensure that it reaches in the components.   http://www.amplifiedparts.com/products/S-CF100S-L2 
#6
 Try Fader lube first,  most times you would need to dissassemble the fader or pot to use fader grease
#7
found it,  a bad cap at c23,24 or 25 (I pulled all three to test) two read .98uf and the third read 3.1uf.  giving an update hope it will help someone later
#8
Hi all,  I am having an issue with my harbinger,  it is working with the exception that if I move the speed pot below 1/3, the lfo apparently shuts down,  any ideas?   Thanks jeff
#9
Global Annoucements / Re: March release schedule
March 26, 2013, 10:10:21 PM
great to see the quantity of each part. Thanks
#10
Open Discussion / Re: POLIDA - MN3005
March 13, 2013, 03:04:29 PM
Crossing my fingers too.. Just ordered 4 of his mn3008
#11
Open Discussion / Re: Charge Pumping a Neovibe..
January 14, 2013, 11:51:00 PM
yes,  I built my neovibe using a charge pump,  I would use the lt1054
#12
Open Discussion / Re: Guitar repair part sources?
November 06, 2012, 07:43:34 PM
If you are  business you should be eligible to join http://www.cedist.com/  Their main business is tube ralated,  but the have a very decent guitar parts selection.  Good luck  Jeff