Messages

The only way I can bias the BBDs is with both of them installed. I can bias it just fine, I just don't have delay with IC7 out. Is this ok? I'm using the clone MN3005 BBDs.

I think I figured it out. As I was building the second one, I discovered I swapped the polar and non polar 2u2 caps.


Sent from my iPhone using Tapatalk

Those look fantastic. You can get white water slide paper in addition to clear. It really changed how I did things.


Sent from my iPhone using Tapatalk

Hey, that's a great tutorial. It's what diy is all about. I use the drill guides listed on the build docs. I also like to just place the components on and mark the the drill holes. I will always be close but off on a 1590a, they're just too damn small for my old eyes.

Boom, I feel like I need to build an Uber tuber now.

Wow, that is beautiful. I love the hummingbird inlays.

Yep, it's been sometime.  I got the resistors  mostly populated, so I'll have to remove them and start again. Doh!


Sent from my iPhone using Tapatalk

My Aquaboy is way different than the BOM. There are spots in the board for which there are no numbers on the BOM and pets are moved around. R30 for example. On the board it's above where it says aquaboy and on the build doc, r30 is to the left of IC2. My C34 and 35 are where C31 and 32 are on the build doc.


Sent from my iPhone using Tapatalk

That looks fantastic. Interesting contrast in the sound of the drive vs the looks. I dig it.


Sent from my iPhone using Tapatalk

That looks incredible, and so clean in and out.


Sent from my iPhone using Tapatalk

You mean like a looper? Check out these guys.

http://jmkpcbs.com/product-category/epic-bypass-looper/

Thcustom has one and so does BYOC.


Sent from my iPhone using Tapatalk

Have any other values like a 2k or 5k?

Sent from my iPhone using Tapatalk

100k is the lowest reverse audio...5k, the lowest audio for this type pot

A5k wires backwards will work, throw 5k resistor on it.


Sent from my iPhone using Tapatalk

Daaaammn that enclosure is all kids of full, with kickass graphics. Nicely done. Is that a 125 b? The perspective throws me off.


Sent from my iPhone using Tapatalk

Have any other values like a 2k or 5k?


Sent from my iPhone using Tapatalk

Lets not confuse mlcc (multi-layer ceramic capacitor) with dipped film caps.  Dipped (or conformal coated) is the form factor used for most mlcc caps but also for some film caps.

Good point.