Messages

You gotta wire your D.C. Input to the 1/4" input. You use green for in and yellow for out also, I've done that for several years now.


Sent from my iPhone using Tapatalk

Move along

15% Discount Coupon Code : "MENTOS"
**Valid till 2 MARCH 2017 ( 6pm New York time )


Sent from my iPhone using Tapatalk

Boom, I'm in.


Sent from my iPhone using Tapatalk

I'm not sure where the 9 dollar amount came from. They are 6.67 on ebay.

Shipping I saw was around 3.00


Sent from my iPhone using Tapatalk

That's really awesome. I wonder how easy it would be to diy one.

I think the pcb wouldn't be hard. i think the ring lens is harder to do or aquire.

will be interesting to see if the 3pdt switches themselves are of any quality.

At 9 bucks per, I'd be slightly irritated with anything less.


Sent from my iPhone using Tapatalk

That's really awesome. I wonder how easy it would be to diy one.


Sent from my iPhone using Tapatalk

That's really nice of you, all the way around.


Sent from my iPhone using Tapatalk

That's pretty awesome. I usually just copy and paste but the sizing always ended up a little off, thank you.


Sent from my iPhone using Tapatalk

I've never had that happen or heard of it. I did switch to rustoleum glossy.


Sent from my iPhone using Tapatalk

That's sick!


Sent from my iPhone using Tapatalk

Ground the jacks, both of them.


Sent from my iPhone using Tapatalk

They offer stuff like that constantly, you should subscribe to the emails


Sent from my iPhone using Tapatalk

Looks like it was 2 things: the DC jack was shorting against the case, and a ground wire not connected to the sleeve of the output jack.

Nice job. Just an FYI for learning purposes. If you use metal 1/4" jacks and are ys by an aluminum enclosure, you don't necessarily need to ground the output jack, it grounds through the enclosure.


Sent from my iPhone using Tapatalk

As it turns out, I'm working on one for lectric-fx right now.

Yesssss


Sent from my iPhone using Tapatalk