Messages

There were a couple times where I fucked up drilling jack holes bad enough that I had to overdrill so much that the washers wouldn't cover up the holes. I found in this situation a leftover plastic washer (I never put the second plastic washer on the outside) from a stomp switch does a good job of covering the hole. It's not the prettiest, but it's better than a gaping hole.

Yep, been there, one on the inside, one on the outside.


Sent from my iPhone using Tapatalk

Ohhhh right. Lumbergs will work there if you didn't want to redrill.


Sent from my iPhone using Tapatalk

Sounds intriguing.


Sent from my iPhone using Tapatalk

I've bent many a lug in my builds, works just fine. Also I've used step less bits to route out the holes, the washers are usually large enough to cover the holes. I don't think drilling new holes is necessary.


Sent from my iPhone using Tapatalk

What style jacks?

Coooooolll


Sent from my iPhone using Tapatalk

prince.org suggests it's feedback coupled with a boss flanger, the silver screw ones from Japan can get a very interesting "pew pew" sound. I figure it's oscillation of some sort.

Very well done.


Sent from my iPhone using Tapatalk

I didn't put any extra LEDs in there just one hidden by the stomp. Sorry for the confusion. You can make it pulse by connecting it to the LM chip and printing the graphic on paper and marking the holes if you were going to do something with them is a great idea. There is a hulk green Russian I did with green light up eyeballs. That was fun.


Sent from my iPhone using Tapatalk

Inkjet water slide.


Sent from my iPhone using Tapatalk

Led on all the time is usually indicative of a short somewhere, check all your solder joints first.


Sent from my iPhone using Tapatalk

Nope, I didn't but it's easy enough to do, I think it's comes of of pin 6 or 7 of the lm13700


Sent from my iPhone using Tapatalk

Cool Deadpool graphic! How do you like the Ross compared to the phase 90?


Sent from my iPhone using Tapatalk

To me, the Ross is a little smoother and even. I love one, I've had one on my board for years.


Sent from my iPhone using Tapatalk

So, the Misses loves the work I do and asked me to build something she could put on her desk to show off her husband....whatever. So obviously, I had to build a phaser, no brainier. The is a Ross clone put to Pcb by a fellow forum member. I've built many of these, but never on a Pcb. I hope you enjoy.



Sent from my iPhone using Tapatalk

Fantastic, really neat design.


Sent from my iPhone using Tapatalk