Messages

Been there before. PT2399's can be flaky also. I have come to the conclusion that no matter who I get them from and how much I pay for them I still get bad ones. I built a bare bones Cave Dweller just to test PTs in.

Cody

Great Idea, there's a vero over on tagboard, I will do that for the same reason.

Well there you go. Thinking outside the box, it's definitely something different. Nicely done. I don't know that I have ever seen a fabricated tonepad pcb.

Got 'em. Need a mirror next.

Man, I always do this part last. I will try it first next time. The hardboard for me is wiring the effect board to the stomp board while it already mounted.  What's the trick there?

No, it's all good. I think a smaller soldering tip kana great idea. I reD that after this attempt, and I discovered at micro size, I shake a bit. Who knew??? I think I can salvage it.

It was the starter kit that got me. I'll try reflowing,at be in a few days, right now I'm going through a few life / living changes and  gonna have to move my "bench" to a different location. I'm optimistic though, u haven't let anything neat me
Yet, except for the one project I melted down. It was cool, but a mark in the loss column.

When I did a 4 in one (2 actually) I used the 1776 stomp boards. Worked out beautifully as the have ground and power in both sides r and. Made it so much easier.

Really nice playing man, I have to get some clear orange leds for mine.

It's a clear orange led?

Welcome!!!

D1 -9.1 v
R2-9.1
r3 -9.1
c2-4.5
trannie base-4.5v

Audio problem yields nothing at the input unless the ground wire and power are disconnected.

Daammnnn

I get this feedback all the time (small, tight etc).  Prehaps I've let my youth get the better of me as I have built 3 of them without a hitch!?  I realise we aren't all steady handy though so I think I will invest a bit of time enlarging the PCB.  That said I do like the fact that this LPB1 is espionage electronics sized

Are you calling me old....again??? :-D

Oh my! I use braid and a desoldering iron too. Braid works great on etched because it's flat as in not double sided , so I'm guessing it works the same way  on e I get a flux pen, I'll be back in business.

Yeah, ot almost looks like coaxial cable you got going on there. Nice job man, building for friends now, what progress you and I have both made! Nicely executed. The closer I g to the end, the more I just want to be done.

Lol hopefully this will, then I've got the function fx board to do.... Msybe