Messages

Uber awesome!!!! does it run at 12v instead of 18v?

hopefully the noise will clean up some once it's boxed.
if they are diffused yellow & green, those things are often very dim.  the only thing you can do is maybe try a lower value on their resistors like 2k2.  it might take some experimentation.

Thanks Haber
I'll buy some yellow BRIGHT and green BRIGHT led with the same 4,7k resistors
Just a doubt.
The ground wire from input sleeve-> output sleeve.
Can I'll remove it when I'll box the pedal?
Thanks!

Yep, it will get continuity through your enclosure.

That's a lot of muff sir! Must be a guitar player....

You'd have to rehouse it to put a stomp on it anyway, then the standard diagram will work. Just think of it as a stomp box that's always on. Reposition the wires from the in and out, shouldn't be a problem.

Does it work out side of the enclosure?

A B Y will work

What happens when you do that? Do you get sound then?

Do you have the dc jack ground connected to the input sleeve also?

Fixed. Having the ic's in the right spots helps....

Did the same thing with the sharkfin.

Looks like you have several joints that are touching, make sure they are supposed  to be.

Top notch!

Awesome pedal

Back when i was getting my enclosure laserized... the goal was to have the laser to go thru the paint for better contrast.

i.e.:

best bass driver ever! Never leaves my board, of course now that I'm not playing it also never leaves the house.

Daaaammnn

You da man!!