Messages

Jimilee, meeting family in Gatlinburg


Sent from my iPhone using Tapatalk

Cool, I'm in Chattanooga

I really appreciate your support guys!!

Recently I ran in to this and just had to bend the solder lugs down and cover them with insulation

Traveling to the TN mountains, pulled off at a Rest Area and found a Gold Mine!!!!


Sent from my iPhone using Tapatalk

Where at? /derail

I'm terribly sorry for your loss. Let me add, are you building pedals instead of spending time with you loved ones? I almost lost my marriage because of things I thought were important. We still have our hobbies, we just try to spend time together when we can, and hobbies in time when we're apart mentally or physically. We're still putting it back together but now we're the road to recovery. Hug your loved ones and put down the soldering iron ,guitar or other distractions when you have the chance to spend time with them. I'm looking forward to catching up with everyone again.

Do you adjust the trimmer?

Looks great, but lemme ask you....how does it taste?

The pcb is the hot wire for the led the ground side of the led goes to lug 1 of your stomp

Yep, you're good to go. I wonder why they used z

I'm asking this, because the schematics image of the on-z-on look very much like those of the on-on-on you sent me.

If the schematics are the same, then it is the same. I was looking at google for what the Z stands for, I got nothing. Not being familiar with that side of the pond, I'm really clueless.   It has 3 throws so it should work with no issues, seems like you'll have an extra position in there which could yield interesting toanz.

dont know, but this is at the bottom if it helps
You don't have to use a 1P12T rotary. You could use a 2P4T, or 4P3T

IMO=in my opinion

Other than the link to small bear in the pdf, here is another place. Lawrence at blms. http://www.bitcheslovemyswitches.com/#!/~/product/category=5324038&id=36073610

Great guy.

Any brand will work. Just make sure it's adjustable from the top, or what I did is use an external pot of the same value so that's it's an adjustable q

What effect, got any pictures of the stomp, have you checked the orientation and polarity of your components. Someone will be along shortly with stern instructions on getting tech help, so go ahead and post clear well lit pictures of the stomp and the board, maybe even a schematic.