Messages

True awesomeness!

Got any pics? Also, are you sure your diodes are oriented correctly?

I love it! Did you use a step less bit for the bezel? Also, Jon is midwayfair not Mayfair. That sound a bit dainty. :-D

I just looked at my schematic for my version of the shoot the moon which includes a mod to urn off the rate LED and it is confirmed to work. For the Grind Customs version you would need to desolder and lift the side of R7 connected to ground and run a wire from that side of the resistor to A1. Or you could remove the resistor altogether and solder one side directly to D1. Then solder a wire to the other end and run it to the R7 PCB pad connected to the rate led.

I was just gonna say this....mind=blown

Great knobs 

Josh

Sean Ryan customs!

this thing sounds insane. Very trippy.

Thanks jon, the combination vibe with the speed knob all the way up on the 45 and phase on the 90 creates a great effect. I believe with a little reverb it would be a whole new level. SCIENCE!!

Excellent

I'm worried by how much air must have been stored inside that horse to produce an expellation so large.

Expellation.....

That's crazy. What do the 2 internal pots do?

The graphics are a waterslide decal over the copper on a PCB then Envirotexed.

On a PCB? Could you clarify / explain how and what PCB you used?

Really cool! How does it sound?

really good. I'll record some audio today

Will fix it today Fixed it. 

How you gonna post this without any sort of cool story? These are great guitars.

That's hilarious

It's actually sticker paper from Office Depot. The paint is red glossy and waterslide won't slide on this paint. It's a real pisser.