News:

Forum may be experiencing issues.

Main Menu

Wolfshirt Enclosure?

Started by tenwatt, October 07, 2011, 11:38:34 AM

Previous topic - Next topic

tenwatt

I'm ordering parts for a Wolfshirt build.   Will that PCB fit in a 1590B?  It looks a little wide.

Also, can I sub a 56n for the 50n in C11?
Not too bright....

Haberdasher

I'm not sure, but I'd probably go with 125b on that.  I'm pretty sure I've seen a build report here in one of those, but not in a 1590b.  125b is so much easier to work with anyway IMHO.

I normally sub 47n for 50, it seems closer, but 56n should be ok too.  Socket it if you want to experiment later.
Looking for a discontinued madbean board?  Check out my THREAD

FABBED PCB's FOR SALE:
Now carrying Matched JFETS

bigmufffuzzwizz

The last page of the Wolfshirt's build doc has a drill template to fit it in a 1590B/1290NS. It looks like it's made to fit that size almost exactly. I agree the 125B would be easier, its a little wider, a little bigger on the length size and good amount deeper. But if you want a challenge, yes it will fit.  :)
Owner and operator of Magic Pedals