News:

Forum may be experiencing issues.

Main Menu

Mesa JCM800 restoration

Started by marauder, September 10, 2013, 10:31:45 AM

Previous topic - Next topic

soldersqueeze

Damn, this is epic! Really great work as usual, guys.

Quote from: hoodoo on September 12, 2013, 08:46:19 AM
Geez, i wish You 2 were my mates that fixed my broken shit and made it better than new, awesome as always  :)

+1

peterc

#16
QuoteUsing Rick Holt's 555 SMPS (http://www.diystompboxes.com/smfforum/index.php?topic=74088.120 Page 6-7). Though Cleggy has used a bigger inductor. Tried a Nixie PSU and it created a lot of noise for some reason. This one is not ideal on vero, but seems to work fine. It's been given a good long test.
Quote

Thanks for that.
Peter
Affiliation: bizzaraudio.com

marauder

#17
This is the original article about the PSU
http://www.ledsales.com.au/kits/nixie_supply.pdf

Reading the DIYSB thread it seems that a 150uH inductor is better than the original 100uH, mine is a 120uH, 2.5A rated one, it doesnt get hot, but the mosfet does and needs a heatsink.

The vero layout is slightly wrong, the 2.2k and 100pf are on the wrong side of the UF4004 diode.



gtangas

Hey...

I have one vtwin open in my table with a stupid problem
.maybe you can help me

The previous owner send it to repair but on the OD channel the output is to weak.you can ear it but...

From the look of the PCB only the vActrols was changed y new ones. Can I jumper the ldr side of the vactrol just to check if the problem is there?

Thx
Sérgio



marauder

Should work jumping the resistor side of the vactrols.  What vactols are they?  This one had VTL5C9s.

Here's a schematic.
http://tubefreak.com/v-twinp.gif

gtangas


gtangas







I think this one was in time moded...

marauder

No idea what's going on there.

The jfet is part of the bypass switching.  Is the cap connected between the jfet and pot?


gtangas

Yes it's connected to the pot...
The problem with this units is low gain
The tubes are new and the vactrols ware replaced by a guy

Do you think the problem could be on that cap?

Vallhagen

Fantastic and ambitious job! Im impressed!

Yes i still have Blüe Monster pcb-s for sale!

...and checkout: https://moodysounds.se/

masterlk