News:

Forum may be experiencing issues.

Main Menu

AION Cerulean built to MG Specs

Started by mjcyates, December 05, 2013, 05:25:55 PM

Previous topic - Next topic

mjcyates

This is an Aion Electronics Cerulean board built to Morning Glory specs. This is a great sounding low gainer. The board was excellent as was the build documentation. Fired up first time with no problems. Highly recommended. I also have the Aion Stratus board that I will be building next. I believe I will be building it to Fulldrive specs.




selfdestroyer

Very clean wire job you have there. I am inlove with my MG clone. I have built a few of them but have yet to do Aion's layout.

wretched

Looks great, I really like the Gear like stomp Switch.

Vice/President

Looks great! What do you mean when you say it's built to MG specs?

selfdestroyer

Quote from: Vice/President on December 05, 2013, 06:37:45 PM
Looks great! What do you mean when you say it's built to MG specs?

I think hes talking about MG=Morning Glory its a JHS Morning Glory which is a modded Marshall Bluesbreaker. Great sounding pedal.

mjcyates

QuoteVery clean wire job you have there.

Thanks the 3PDT switch board from Josh makes wiring so much easier.

QuoteLooks great, I really like the Gear like stomp Switch.

Thanks I ripped off that idea from one of our fellow madbeaners. I think it adds a nice touch, especially since I never do any graphics on my builds.

QuoteWhat do you mean when you say it's built to MG specs?

Morning Glory. As in the JHS Morning Glory. It as well as the Analogman King of Tone are just different variations on the Marshall Bluesbreaker circuit.


wretched

Ripped off or not I might try something like this

It looks very steampunk. you should add a small copper handle on the top from an old cupboard or something.

Jakes Dad

Oh, nice build.  Good job.  Those are nice aren't they?

Chuck

mjcyates

I used this live tonight for the first time and it sounded great. Really like this one for low gain rhythm stuff.

aion

Very nice! Inside and outside are pro all the way. Were the jacks low enough to give the 3PDT board enough clearance?

mjcyates

QuoteVery nice! Inside and outside are pro all the way. Were the jacks low enough to give the 3PDT board enough clearance?

Thanks. Yes the jacks were low enough so that I did not have any clearance issues. I will post my Stratus build when I get it completed.

gjcamann

I build the AION Fulldrive and am very pleased.  I'm almost done with the KOT build. Maybe i'll have to get another and try the MG build.