News:

Forum may be experiencing issues.

Main Menu

Switching Klon schematic to a true bypass

Started by mark123, February 22, 2016, 12:19:30 AM

Previous topic - Next topic

mark123

I was looking at the Klon schematic and noticed there are components in the path when the effect is off so can I just leave those out?
The original schematic:


Can I leave out these bits:

and then connect the output pot wiper to the out jack?

Lubdar

i think you'd be interested in the 2015 kingslayer
(--c^.^)--c

electrosonic

That looks right. I did the same thing with a cheap Klon kit I got off eBay.

Andrew.

mark123

Quote from: Lubdar on February 22, 2016, 02:11:46 AM
i think you'd be interested in the 2015 kingslayer
It would probably be an easier path but I'm trying to learn to use Eagle and modify circuits. :)  It's sure a lot of fun.

mark123

Quote from: electrosonic on February 22, 2016, 06:54:12 AM
That looks right. I did the same thing with a cheap Klon kit I got off eBay.
Andrew.
Great!  I'm going to breadboard this out if it will fit. So far it looks like it would be easier to submit it to oshpark though. ;)