Author Topic: Dark Horse Mids - Mids cap values  (Read 524 times)


  • Solder Ninja
  • ****
  • Posts: 270
  • Ralf
    • View Profile
Dark Horse Mids - Mids cap values
« on: September 02, 2017, 03:14:03 PM »
Hey everyone,

I ordered the Dark Horse Mids board from Osh Park.  It's one of the designs that are unverified.  I built it up, and we can consider it verified.  It sounds pretty good.  I do have a question as the two caps that come off the Mids pot were unlabeled.  Played around with some values and I used mTR - 10n and mBA - 4.7n.  I tried some others and settled on these.  It works, though the sweep is pretty big.  I was wondering if anyone who has the schematics has any other ideas for some values.  I'm stabbing a bit blindly here.

I know there are a ton of people here who could probably point me in the right direction, but unfortunately I can't really share the schematic...
Dr. Von Fuzzbrauer @ Rocket Surgeon Effects Pedals