News:

Forum may be experiencing issues.

Main Menu

How do I tell if the nsl is backwards in my bumblebee

Started by jimilee, May 22, 2020, 01:45:03 PM

Previous topic - Next topic

jimilee

I put the dot on the bottom where the doc says to, but it measures positive instead of negative and when I attach and LED to the legs, it doesn't light up.


Sent from my iPhone using Tapatalk
Pedal building is like the opposite of sex.  All the fun stuff happens before you get in the box.

Aentons

 Negative on top, positive on bottom. Not sure but I'd use a meter and see if there is any voltage between those two. Twiddle the sustain and trigger knobs while you do it

Aentons

ok, I see... after looking at the build doc it looks like the dot (cathode) goes on top (not the bottom).

"The cream dot on the part denotes the cathode of the internal
LED on the optocoupler and should be placed as shown above"

jimilee

Quote from: Aentons on May 22, 2020, 02:50:17 PM
ok, I see... after looking at the build doc it looks like the dot (cathode) goes on top (not the bottom).

"The cream dot on the part denotes the cathode of the internal
LED on the optocoupler and should be placed as shown above"
Thank you. I've never once gotten an opto right on the first try.


Sent from my iPhone using Tapatalk
Pedal building is like the opposite of sex.  All the fun stuff happens before you get in the box.