Author Topic: deadringer leds  (Read 1129 times)

bhound

  • Diode Destroyer
  • *
  • Posts: 11
    • View Profile
deadringer leds
« on: July 30, 2010, 06:30:50 PM »
The deadringer layout does not show where to land the + side of the leds. Does it matter? Since the 3pdt is in control.

madbean

  • Administrator
  • Electron Doctor
  • *****
  • Posts: 9498
  • Brian
    • View Profile
    • madbeanpedals
Re: deadringer leds
« Reply #1 on: July 30, 2010, 07:46:45 PM »
You'll want to add the current limiting resistor and LED off-board to the 9v supply of the DC jack. The other end hooks up to the 3PDT's as shown in the wiring diagram. I removed the on-board LED's in this version to make the board smaller (so it could fit in a 1590B). But, there's nothing special about how they are hooked up.
No matter where you go, there I am. Watching you.