Project docs are going up and will continue throughout the week. Shooting for a Saturday or Sunday release.
I hit a major snag on the IMP2022. Even though it was built, boxed and sounding just fine when I got down to taking voltage measurements I found DC at the input which absolutely should not be there. I've spent hours trying to figure out what's going on. Removed, replaced parts, built a second board, even removed silk screen to expose traces. I simply can't find the fault or source of the DC. This is a major bummer since these boards were expensive and I've already invested a lot of time into it. But, such is the life of developing and releasing products as a sole proprietor. Maybe I'll be able to figure it out in the next few days, or maybe it will get shelved:( I did skip the prototying stage for this and went straight to production. I felt safe doing so since it's a proven project. Perhaps that was a big mistake.
