I just ordered 2 of these!!!

[midwayfair]

hah, one is for a klone.

[flanagan0718]

Could some valve based things fit in those holes or are they too big?

Hmmmm. It would be worth checking! I was planning on doing a little watter.

[Willybomb]

Would have got some, but not for $39 shipping to AU.

[GermanCdn]

Could some valve based things fit in those holes or are they too big?

They're close, might actually be slightly on the small side for a 9 pin socket.  The bigger problem is that they are machined for two other large holes on the sidewalls as well.

[blearyeyes]

Well you could add some plastic eyeballs in the bigger holes and put blinking LEDs in them...

[pk1802]

I ordered one of the packs of 6 as well. My grouping looks a lot like everyone elses. I have one 1590bb drilled for a multi, A big pink box(1790?) drilled for 10 knobs, two 1590bs, one for 4 knobs and the other 2 knobs, and a 1590a drilled for two jacks, led and a switch.(I'm assuming a loop or channel switch).

Annnd then there is the silver guy with 4 giant holes. I was going to see if xlr's fit in the holes. I may make a two channel phantom power supply(as my mixer doesn't have phantom) and use the serial port looking hole as the power supply.

[gordo]

Ummm...to be PC I think the term "fat kid" should be "oversized young American" 

[jkokura]

That orange 1790NS looks like it could be a bad Blackout Effectors enclosure...

Jacob

[flanagan0718]

Ummm...to be PC I think the term "fat kid" should be "oversized young American" 

haha. You're right , I'll watch my mouth next time

That orange 1790NS looks like it could be a bad Blackout Effectors enclosure...

Jacob

I was thinking about putting a reverb/delay 2 in 1 in that bad boy!