News:

Forum may be experiencing issues.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - gül

#61
Just ordered some.  ;)
#62
Tech Help - Etcher's Paradise / Re: Horndog attempt
February 18, 2016, 06:19:39 PM
I gave that a try, Alparent. Re-flowed solder all around one more time, too. Same weird result! I'm curious to see how yours turns out when you get to it!

When it is working (meaning when I have my finger on that junction), it suffers from the high-pitched sound that is always there in the background... Same as the TagboardFX version I built. It must just be part of the design. It's a very cool-sounding effect nonetheless. 
#63
Tech Help - Etcher's Paradise / Re: Horndog attempt
February 17, 2016, 09:45:58 PM
The jumper is in, that's why I'm confused!
#64
Tech Help - Etcher's Paradise / Horndog attempt
February 17, 2016, 08:31:51 PM
I etched and built the Horndog. Weirdest thing is that the effect only works when I touch the side of R6 (100k) that connects to pin 3 of IC2 with my finger.  ???

Granted, I really am a hack when it comes to understanding this stuff... But it would be great to know what I can connect to make it work. I should point out that the effect works perfectly when I touch it in that one spot. I'm getting a nice sweep, even with a 1MB pot. Anyone have any ideas about where a connection needs to be made? I've checked my solder points around there and I have continuity all around. I'm stumped but this has been really fun to work on. :)
#65
It's gorgeous. Where did you get the little short bat toggle? The ones I have are kinda janky and not that durable. I love the look of them and would love to find somethat are a higher quality.
#66
Luckily I have an awesome electronics store nearby that sells the stuff. It's gonna cost more than I was paying for abcfab's stuff but at least I'm supporting a local business. If anyone on here lives in the Bay Area, check out Al Lasher's if you haven't already!
#67
Greetings everyone,

It appears that the seller I've been buying Copper Clad Laminate Board from on eBay (abcfab) is away until July. Can anyone recommend another vendor to buy from?

Thanks!
#68
Build Reports / Re: Behemoth / Ezekiel
February 06, 2016, 06:31:03 PM
Did these ever get finished?