Topics

Hello. I recently acquired a Voyager and when the pedal is engaged, a choppy, tremolo effect turns on, the volume of which increases when the volume is turned up. All other knobs do nothing. Also, sometimes the pedal's LED turns on and the popping noise is gone, but there is still no effect. Any clue as to what may be causing this? Thanks in advance.

Ok. When I first plugged in after wiring it up, I got sound only when the input cable was halfway in the input jack. Also, the sound I got was certainly not a RAT sound; the volume and gain were all the way up and it just did not sound like a RAT. After taking some advice from this forum, I rewired and now I only get a loud hum from the pedal. I'm relatively new at pedal building so take it easy on me and I highly appreciate the help.

Ok, guys. I'm wiring up my Slow Loris and have to somewhat of an issue in regards to wiring the power supply jack. On the wiring diagram, it shows the jack connected to a battery snap which I have no intention of using. Can someone please help me by explaining what gets connected to the power supply jack? thanks in advance.

I'm building the Slow Loris in an enclosure with drilled holes that won't allow me to used board mounted pots or the toggle. My problem stems from this in that the holes on the board seem rather large to facilitate the pot wires. Any suggestions? Thanks.

hello folks. I've got my zombii built but the volume knob doesn't fluctuate the volume when turned. Any help or suggestions? Thanks

How would you wire a 6 prong footswitch for the Zombii Fuzz Factory clone?

Ok so I've just finished my Slam Box and it works perfectly. My only concern comes from the fact that the LED turns on when I stomp the footswitch without the battery in. Is this something to be concerned about? Thanks.

Hey folks. I'm wiring up my first build and I'm confused as to what the sleeve, ring and jack are. I'm going by the madbean wiring diagram. I appologize for such a rookie question. Thanks guys.

Hey guys. Completely new to this and have run into what I'm sure is a very rookie question: how do I know the wiring routes from the PCB to the footswitch? I clicked on the link that's supposed to redirect me to wiring help but it simply says "coming soon." Any help will be appreciated folks. Thanks.