Hey,
I've never built a pedal before but have some experience in building arduino projects and the like. So I thought I'd give this a shot. I ordered three PCBs which arrived today and had a getting started question.
Basically, what do i do with those red lines? The impression I get is that I am supposed to solder a jump wire from one to the next, for instance from R3 to C8. If so how should I go about this? Solder both the jump wire and the resistor together where it's indicated and then the capacitor and the other end of the wire as indicated?
Thanks
I've never built a pedal before but have some experience in building arduino projects and the like. So I thought I'd give this a shot. I ordered three PCBs which arrived today and had a getting started question.
Basically, what do i do with those red lines? The impression I get is that I am supposed to solder a jump wire from one to the next, for instance from R3 to C8. If so how should I go about this? Solder both the jump wire and the resistor together where it's indicated and then the capacitor and the other end of the wire as indicated?
Thanks