News:

Forum may be experiencing issues.

Main Menu

Greasy Mullet (Zendrive)

Started by jimmybjj, February 27, 2014, 10:44:36 PM

Previous topic - Next topic

jimmybjj

A friend asked me to build a zen for him, this was the result. I left it in my oven for too long, so the embossing effect i was going for was ruined, not happy with finish but he is getting it for free  ;)

The circuit is a stock zen. The 3pdt pcb is a switchable buffer wired for buffer only. I used a dual opamp with the extra opamp terminated, just because i have lots of extra duals :)



Pcbs no longer available

rullywowr

Nice build. The Lego construction worker was a nice touch



  DIY Guitar Pedal PCB projects!

bcalla

That's amazing!  How did you achieve the raised lettering and graphic?

jubal81

Could've put a lego surgeon in there. It's tidy enough inside for an operating room. Just outstanding work - great layouts and execution.
"If you put all the knobs on your amplifier on 10 you can get a much higher reaction-to-effort ratio with an electric guitar than you can with an acoustic."
- David Fair

murdog47


Govmnt_Lacky

The switching board is almost as big as the Zen board!

Very tidy work!

pickdropper

That's about as clean as it gets.  Great graphics, too.
Function f(x)
Follow me on Instagram as pickdropper

billstein

Nice inside and out. I'd also like to know how you achieved those raised letters.

lincolnic

Lego Peeps or GTFO.

Seriously though, this pedal is insane. Amazing job.

jfk1063


Mich P


jimmybjj

Thanks for the compliements fellas :)

Quote from: Govmnt_Lacky on February 28, 2014, 01:29:23 AM
The switching board is almost as big as the Zen board!

Their are a couple of extra components that normally wouldn't be used, to properly terminate the floating opamp.

Quote from: bcalla on February 27, 2014, 11:15:01 PM
That's amazing!  How did you achieve the raised lettering and graphic?

I didn't get it quite right this time, so it normally looks better. I have a vinyl cutter that i layer the same design over about 6 times, the power coat over it. its a tedious process that you have to lower and extend your cure time for the power to prevent the vinyl from melting, like it did here :)

Quote from: murdog47 on February 27, 2014, 11:58:43 PM
Nice layout! Is it shared?
Quote from: jfk1063 on February 28, 2014, 07:07:21 AM
Got any left??

I have one left.
Pcbs no longer available