Author Topic: Switching Klon schematic to a true bypass  (Read 2214 times)

mark123

  • Stompbox Star
  • ***
  • Posts: 152
  • I trusted the Autorouter
    • View Profile
    • Imagine Kitty Magazine
Switching Klon schematic to a true bypass
« on: February 21, 2016, 06:19:30 PM »
I was looking at the Klon schematic and noticed there are components in the path when the effect is off so can I just leave those out?
The original schematic:


Can I leave out these bits:

and then connect the output pot wiper to the out jack?

Lubdar

  • Solder Ninja
  • ****
  • Posts: 296
    • View Profile
Re: Switching Klon schematic to a true bypass
« Reply #1 on: February 21, 2016, 08:11:46 PM »
i think you'd be interested in the 2015 kingslayer
(--c^.^)--c

electrosonic

  • Stompbox Star
  • ***
  • Posts: 133
    • View Profile
Re: Switching Klon schematic to a true bypass
« Reply #2 on: February 22, 2016, 12:54:12 AM »
That looks right. I did the same thing with a cheap Klon kit I got off eBay.

Andrew.

mark123

  • Stompbox Star
  • ***
  • Posts: 152
  • I trusted the Autorouter
    • View Profile
    • Imagine Kitty Magazine
Re: Switching Klon schematic to a true bypass
« Reply #3 on: February 22, 2016, 07:28:50 AM »
i think you'd be interested in the 2015 kingslayer
It would probably be an easier path but I'm trying to learn to use Eagle and modify circuits. :)  It's sure a lot of fun.

mark123

  • Stompbox Star
  • ***
  • Posts: 152
  • I trusted the Autorouter
    • View Profile
    • Imagine Kitty Magazine
Re: Switching Klon schematic to a true bypass
« Reply #4 on: February 22, 2016, 07:30:41 AM »
That looks right. I did the same thing with a cheap Klon kit I got off eBay.
Andrew.
Great!  I'm going to breadboard this out if it will fit. So far it looks like it would be easier to submit it to oshpark though. ;)