Author Topic: Switch Schematic Help  (Read 726 times)

MilkyWayAudio

  • Diode Destroyer
  • *
  • Posts: 2
    • View Profile
Switch Schematic Help
« on: February 11, 2017, 07:27:49 PM »
I'm trying to replicate part of a schematic and was wondering if what I have done is equivalent to the original. Also if someone could explain the rule to what would make this work/not work that would be great!

Thanks for the help!!  ;D

reddesert

  • Solder Ninja
  • ****
  • Posts: 252
  • Ben
    • View Profile
Re: Switch Schematic Help
« Reply #1 on: February 11, 2017, 08:27:32 PM »
Those aren't equivalent for two reasons:
1. In the top schematic with the 1P3T switch, FX IN is always connected to the bias voltage through the resistor/capacitor network, even if the switched part is not connected to the res/cap network.
2. The resistor values connected to the bias voltage are different.